This little device has a remote photosensor and a 10 Amp solid state, 12 volt relay
which will automatically switch on your sidelights or marker lights when ambient light inside
the vehicle drops to a preset level (adjustable with a small screwdriver through the side of the case).
NOTE: The ‘Lights On’ function will be delayed for five seconds after ignition is turned on to ensure
full battery supply is available for cranking.
Sensor cable 1.5mtrs long cable.
EARTH - Bolt through the metal relay base to a clean -12 volt, earth point on your vehicle
or connect earth to the base with a ring terminal.
RED - +12 Volt Ignition feed in.
BLUE - out to switch on dipped beam via it’s relay. 5 Amp max.
YELLOW - +12v out to side lights. 5 Amp max.
GREEN - connect to the live feed on your sidelight switch. 10 Amp max.
NOTE: Do not mount the sensor in direct daylight. Mount inside the vehicle. Experiment with the position before final fitting.